Banners HemiTruckClub.com Website DiabloSport Website Superchips Website Henson Motor Sports Website 3rd Strike Performance We Support Our Troops United States of America Canada United Kingdom Belgium Iceland France Germany Puerto Rico South Africa Guam Netherlands

HemiTruckClub.com    HTC.com Forum    Forums  Hop To Forum Categories  HEMI performance  Hop To Forums  Headers    Pacesetters installed....now running rich
Page 1 2 

Moderators: MrHemi
Go
New
Find
Notify
Tools
Reply
  
-star Rating Rate It!  Login/Join 
"Dustin"

President
Kentucky Chapter
Picture of gottahemi
Posted
I installed a set of Pacesetter Long tubes, removed the cats, and connected true dual 3" pipe with 2 Flowmaster 40 series mufflers. Before I did this change to my exhaust my cyberdyne A/F gauge would normally read somewhere in the middle of Lean/Rich while driving. Hit WOT and it would go to Rich. Normal I thought. After the change to my exhaust the A/F gauge reads full rich all the time. I just recently had a header gasket blow and with the exhaust leak the A/F was back to moving around. Is this normal to be in a rich condition with this setup. I know the A/F gauge is a shortband and pretty much a waste of money unless you like to see the lighs. Need some opinions. Thanks in advance


04 Hemi Ram QC 4x4.......Slightly Modified



 
Posts: 991 | Location: Lawrenceburg, Kentucky | Registered: 25 May 2007Reply With QuoteEdit or Delete MessageReport This Post
Picture of Harrison_71459
Posted Hide Post
Did you ever figure this out. I have edelbrock mids but I ordered a set of pacesetter longtubes thinking It would be an improvement????

Randy
 
Posts: 63 | Location: Back in the states | Registered: 23 November 2006Reply With QuoteEdit or Delete MessageReport This Post
Picture of Starchief_59
Posted Hide Post
I always heard headers make you run lean


1959 Buick Electra 4 Door Sedan
1959 Pontiac Star Chief 4 Door Hard Top
1976 W200 Dodge Power Wagon 383/ 727 4x4
1986 W100 Dodge Power Ram 318/ 4 speed 4x4
2007 Dodge Ram Single Cab Long Bed - almost no options except posi and HEMI!
www.Pontiac-59.com
 
Posts: 2003 | Location: San Marcos, Texas | Registered: 05 September 2007Reply With QuoteEdit or Delete MessageReport This Post
"Jordan"
Picture of 04LaramieQC
Posted Hide Post
iagree


_____________
2004 QC 2WD
Comp 268 cam, 6.1L valvesprings/pushrods, Pacesetter Jet-Hot coated LT's/ORY, K&N intake, Taylor shorties, Borla XR1 dumped, 3.92/posi rear, SCT tune by Hemifever, short belt for the track, 15% tint, 2" drop shackles, debadged except fenders
 
Posts: 773 | Location: Shreveport, LA | Registered: 22 January 2008Reply With QuoteEdit or Delete MessageReport This Post
"Bill"



President
FL Chapter

Florida Chapter
Truck of the Year 2008
Picture of arocketman
Posted Hide Post
Time for a wide band and a programmable tuner. Big Grin


2005 1500 QC Thunder Road
Slightly Tweaked

 
Posts: 2554 | Location: Space Coast, FL | Registered: 04 August 2007Reply With QuoteEdit or Delete MessageReport This Post
"Dustin"

President
Kentucky Chapter
Picture of gottahemi
Posted Hide Post
quote:
Did you ever figure this out. I have edelbrock mids but I ordered a set of pacesetter longtubes thinking It would be an improvement????

I love my Longtubes. Makes a big difference over stock. I think part of my issues may be the O2 sensor that I have connected to my A/F gauge. I have a new one just haven't had the chance to swap them out. I do need to a wideband though.


04 Hemi Ram QC 4x4.......Slightly Modified



 
Posts: 991 | Location: Lawrenceburg, Kentucky | Registered: 25 May 2007Reply With QuoteEdit or Delete MessageReport This Post
Picture of hemicrazy08
Posted Hide Post
to gottahemi how loud is your exhaust and dose it sound good? i have AN 08 SINGAL cab and i ran true dual 2.5 from manifold and removed cats with 2 flow 40s and it sounds like a tin can/ a very loud one!
 
Posts: 13 | Location: hemicrazy08@aol.com | Registered: 12 March 2009Reply With QuoteEdit or Delete MessageReport This Post
"Michael"



Truck of the Month
July 2006

Picture of hemi_loredo03
Posted Hide Post
quote:
Originally posted by arocketman:
Time for a wide band and a programmable tuner. Big Grin

iagree


____________________________________________________
MY RIDE
2004 1500 Hemi RCSB\Inertia Motorsports Spartan Cam\Inertia Motorsports CNC Ported 5.7 Heads\AEM Wideband A/F Gauge\SCT TUNED\Flex-A-Lite Electric Fan\180 Thermostat\Shorty Taylor Wires\NGK 5306 Plugs\aFe Cold Air Intake System\Long Tube Pacesetter Headers\Cat Delete\Dual DMH Electric Cutouts\Magnaflow X Pipe\True Duals with 2 AeroTurbine 3030's dumped\Motive 4.56 Gears with LSD\SharaDon Performance Stage II Transmission with Stage III Valve Body\Edge 3000 Billet Torque Converter\Cal Tracs\McGaughy's 2/4 Drop

Click here for pics and couple vid's of my truck!
 
Posts: 2621 | Location: Waco, TX | Registered: 07 November 2004Reply With QuoteEdit or Delete MessageReport This Post
Picture of Starchief_59
Posted Hide Post
I put a wideband on my truck after my header swap and I'm in the 12.1-12.5 range up until about 4500. From 4500+ I was in the high 11s. I adjusted it with my Diablo and now I'm in the 12.1-12.5 all the way through.


1959 Buick Electra 4 Door Sedan
1959 Pontiac Star Chief 4 Door Hard Top
1976 W200 Dodge Power Wagon 383/ 727 4x4
1986 W100 Dodge Power Ram 318/ 4 speed 4x4
2007 Dodge Ram Single Cab Long Bed - almost no options except posi and HEMI!
www.Pontiac-59.com
 
Posts: 2003 | Location: San Marcos, Texas | Registered: 05 September 2007Reply With QuoteEdit or Delete MessageReport This Post
Picture of BADREDRAM
Posted Hide Post
I have a Superchips tuner and I was wondering if you can adjust your A/F ratio with it.
 
Posts: 60 | Location: Hobart, IN | Registered: 16 May 2009Reply With QuoteEdit or Delete MessageReport This Post
"Zachary"

VP
OK Chapter
Picture of zwa21
Posted Hide Post
Don't think you can with S/C.
 
Posts: 5481 | Location: Perry, Oklahoma | Registered: 18 May 2007Reply With QuoteEdit or Delete MessageReport This Post
"Michael"



Truck of the Month
July 2006

Picture of hemi_loredo03
Posted Hide Post
quote:
Originally posted by BADREDRAM:
I have a Superchips tuner and I was wondering if you can adjust your A/F ratio with it.

Sorry bro, you need a custom tuner. SCT or Diablo are your only custom tuners out. What year is your truck? SCT only supports up to 04 - 07 and Diablo supports 03-08 I believe.


____________________________________________________
MY RIDE
2004 1500 Hemi RCSB\Inertia Motorsports Spartan Cam\Inertia Motorsports CNC Ported 5.7 Heads\AEM Wideband A/F Gauge\SCT TUNED\Flex-A-Lite Electric Fan\180 Thermostat\Shorty Taylor Wires\NGK 5306 Plugs\aFe Cold Air Intake System\Long Tube Pacesetter Headers\Cat Delete\Dual DMH Electric Cutouts\Magnaflow X Pipe\True Duals with 2 AeroTurbine 3030's dumped\Motive 4.56 Gears with LSD\SharaDon Performance Stage II Transmission with Stage III Valve Body\Edge 3000 Billet Torque Converter\Cal Tracs\McGaughy's 2/4 Drop

Click here for pics and couple vid's of my truck!
 
Posts: 2621 | Location: Waco, TX | Registered: 07 November 2004Reply With QuoteEdit or Delete MessageReport This Post
Picture of Starchief_59
Posted Hide Post
SCT does 07s now?


1959 Buick Electra 4 Door Sedan
1959 Pontiac Star Chief 4 Door Hard Top
1976 W200 Dodge Power Wagon 383/ 727 4x4
1986 W100 Dodge Power Ram 318/ 4 speed 4x4
2007 Dodge Ram Single Cab Long Bed - almost no options except posi and HEMI!
www.Pontiac-59.com
 
Posts: 2003 | Location: San Marcos, Texas | Registered: 05 September 2007Reply With QuoteEdit or Delete MessageReport This Post
"Michael"



Truck of the Month
July 2006

Picture of hemi_loredo03
Posted Hide Post
quote:
Originally posted by Starchief_59:
SCT does 07s now?

I could be wrong but I thought they did. dunno


____________________________________________________
MY RIDE
2004 1500 Hemi RCSB\Inertia Motorsports Spartan Cam\Inertia Motorsports CNC Ported 5.7 Heads\AEM Wideband A/F Gauge\SCT TUNED\Flex-A-Lite Electric Fan\180 Thermostat\Shorty Taylor Wires\NGK 5306 Plugs\aFe Cold Air Intake System\Long Tube Pacesetter Headers\Cat Delete\Dual DMH Electric Cutouts\Magnaflow X Pipe\True Duals with 2 AeroTurbine 3030's dumped\Motive 4.56 Gears with LSD\SharaDon Performance Stage II Transmission with Stage III Valve Body\Edge 3000 Billet Torque Converter\Cal Tracs\McGaughy's 2/4 Drop

Click here for pics and couple vid's of my truck!
 
Posts: 2621 | Location: Waco, TX | Registered: 07 November 2004Reply With QuoteEdit or Delete MessageReport This Post
Picture of Starchief_59
Posted Hide Post
About time.


1959 Buick Electra 4 Door Sedan
1959 Pontiac Star Chief 4 Door Hard Top
1976 W200 Dodge Power Wagon 383/ 727 4x4
1986 W100 Dodge Power Ram 318/ 4 speed 4x4
2007 Dodge Ram Single Cab Long Bed - almost no options except posi and HEMI!
www.Pontiac-59.com
 
Posts: 2003 | Location: San Marcos, Texas | Registered: 05 September 2007Reply With QuoteEdit or Delete MessageReport This Post
  Powered by Eve Community Page 1 2  
 

HemiTruckClub.com    HTC.com Forum    Forums  Hop To Forum Categories  HEMI performance  Hop To Forums  Headers    Pacesetters installed....now running rich

Copyright HemiTruckClub.com 2009