Page 1 2
Moderators: MrHemi
|
Go
|
New
|
Find
|
Notify
|
Tools
|
Reply
|
|
|
Truck of the Month May 2006 Texas Chapter Court Jester  |
To all owners of 06 and 07's wanting 456's.. The housing has to be ground in order for 456's to fit. DONT let anyone tell you any different and make sure the shop you use to do the install is WELL aware of this. Even if they have been doing gears for 40 years and think they know everything (like my first 2 yoyo's). Starting late 05 the rear-ends are built by American Axle Manufactors NOT Chrysler and are smaller towards the passenger side of the housing which is where the 456's rub because they are a thicker gear.. The gears have to be installed and set, turned by hand to mark the housing then dissasembled and the housing is ground where the marks are for clearance.. No other way.. FYI
This might need to be a sticky post somewhere 2007 SRT8 Jeep GC-Red Rock. 12.58 1/4 JB CMR Tuned / BWoody Intake / 275/315 Michelin Latitude HP / Amsoil Motor, Diffs, Tranny / Xenon Depot 6500K HID Lows/Fogs / LED Interior / Tinted Tails by Red03SilSS / Gloss It Paint Protection / PPG Ceramiclear front end / Borla S / Billet Tech Catch Can / R1 Drilled/Slotted Rotors / AEM UEGO Wideband A/F / WeatherTechs / LIPS Rear Fog Harness LED  |
||
|
"Brian" |
what about 4.10s?
Wreck'em Tech 06 Black Sport QC 1500 Hemi, AERO Stealth 156 Muffler , aFe Stage 2 "High Breather", Pacesetter Mids, Superchips |
|||
|
|
Truck of the Month May 2006 Texas Chapter Court Jester |
Should be fine, but would not hurt to have them verify, does not take that long to make sure
2007 SRT8 Jeep GC-Red Rock. 12.58 1/4 JB CMR Tuned / BWoody Intake / 275/315 Michelin Latitude HP / Amsoil Motor, Diffs, Tranny / Xenon Depot 6500K HID Lows/Fogs / LED Interior / Tinted Tails by Red03SilSS / Gloss It Paint Protection / PPG Ceramiclear front end / Borla S / Billet Tech Catch Can / R1 Drilled/Slotted Rotors / AEM UEGO Wideband A/F / WeatherTechs / LIPS Rear Fog Harness LED |
|||
|
|
Truck of the Month May 2006 Texas Chapter Court Jester |
The place that discovered this was right outside of Houston Texas
2007 SRT8 Jeep GC-Red Rock. 12.58 1/4 JB CMR Tuned / BWoody Intake / 275/315 Michelin Latitude HP / Amsoil Motor, Diffs, Tranny / Xenon Depot 6500K HID Lows/Fogs / LED Interior / Tinted Tails by Red03SilSS / Gloss It Paint Protection / PPG Ceramiclear front end / Borla S / Billet Tech Catch Can / R1 Drilled/Slotted Rotors / AEM UEGO Wideband A/F / WeatherTechs / LIPS Rear Fog Harness LED |
|||
|
"Justyn"  |
Good info CTH! That could me a $$$$ saver for someone. Maybe MrH should post this in the Install section or something so it doesn't get buried. ???
Amsoil Dealer (Greenwood, IN) http://www.lubedealer.com/indyoilguy/ Ph#: 317-383-6061 05 Atlantic Blue 1500 4x4 QC Superchips, Dynomax Bullett, 3rd Strike intake, Taylor Shorties, NGK 2314 Iridium plugs, Amsoil'd out, Tinted windows, torsion lifted, debadged, billet antenna, billet fuel door, Billet front/rear cup holders, tinted 3rd brake light, Ventshades, Line-X, Alpine 9885, Kicker KS series 5.25, and 6.5 components, Kicker KX350.2 amp, Kicker 12" DVC Comp VR Future Dodge Challenger owner...if I am rich or gas prices drop.... Many mods to come....hehehe.            |
|||
|
 |
Good info CTH!
 New Ride: 08 QC 4x4 Hemi Elec Blue "Big Horn" edition 3rd Strike CAI, Jetstream scoop, Powerwire Old Ride: 05 QC 4x4 Hemi     |
|||
|
|
|
CTH- is there a way to make sure which axle you have? I have an 05 but don't know the build date and want to do this.
New Ride: 08 QC 4x4 Hemi Elec Blue "Big Horn" edition 3rd Strike CAI, Jetstream scoop, Powerwire Old Ride: 05 QC 4x4 Hemi |
|||
|
|
Truck of the Month May 2006 Texas Chapter Court Jester |
as long as its labled and 05 your fine,they were contracted in late 2005, but did not go into assembly until 06
2007 SRT8 Jeep GC-Red Rock. 12.58 1/4 JB CMR Tuned / BWoody Intake / 275/315 Michelin Latitude HP / Amsoil Motor, Diffs, Tranny / Xenon Depot 6500K HID Lows/Fogs / LED Interior / Tinted Tails by Red03SilSS / Gloss It Paint Protection / PPG Ceramiclear front end / Borla S / Billet Tech Catch Can / R1 Drilled/Slotted Rotors / AEM UEGO Wideband A/F / WeatherTechs / LIPS Rear Fog Harness LED |
|||
|
|
Truck of the Month May 2006 Texas Chapter Court Jester |
I thought I would bring this back to life and maybe could be a sticky, I had a call from Bob at Moes Metal work and he is seeing alot of the 06/07 guys looking to do this and I just dont want them to run into the same problems
2007 SRT8 Jeep GC-Red Rock. 12.58 1/4 JB CMR Tuned / BWoody Intake / 275/315 Michelin Latitude HP / Amsoil Motor, Diffs, Tranny / Xenon Depot 6500K HID Lows/Fogs / LED Interior / Tinted Tails by Red03SilSS / Gloss It Paint Protection / PPG Ceramiclear front end / Borla S / Billet Tech Catch Can / R1 Drilled/Slotted Rotors / AEM UEGO Wideband A/F / WeatherTechs / LIPS Rear Fog Harness LED |
|||
|
Hmmmm thanks for that INFO!!!
 this is why i check out the forums, you sure can learn alot on here!!07 Dodge Ram 4x4 QC MDS HEMI getting 20+ mpg on the highway True flow intake,Superchip, Magnaflow 3" SI/SO, 180Tstat, Flex a lite E fan, Pioneer AvicD3 navigation with custom white and silver OEM navi dash sport package conversion, black chrome SS grille inserts Weight with me in it - 5480 Track prep = short belt, 20 PSI rear tires, and no spare 1/8 - 9.5004 @ 74.34 1/4 - 60' 2.1820, 14.8766 @ 89.53 Dyno - 281.9 RWHP 304.2 RWTQ Future mods S&S long tube Headers with highflow cats KRC Cam/Head combo and SCT "Hemifever" tuning HTC Titan Killer Club |
||||
|
|
Truck of the Month May 2006 Texas Chapter Court Jester |
This to me is what they should be doing on ALL installs
http://www.drivetrain.com/ringpinioninstal.html 2007 SRT8 Jeep GC-Red Rock. 12.58 1/4 JB CMR Tuned / BWoody Intake / 275/315 Michelin Latitude HP / Amsoil Motor, Diffs, Tranny / Xenon Depot 6500K HID Lows/Fogs / LED Interior / Tinted Tails by Red03SilSS / Gloss It Paint Protection / PPG Ceramiclear front end / Borla S / Billet Tech Catch Can / R1 Drilled/Slotted Rotors / AEM UEGO Wideband A/F / WeatherTechs / LIPS Rear Fog Harness LED |
|||
|
Good thing I am swithcing to an aftermarket LSD
|
||||
|
Great info CTH!!
Moe's Traction Bars (near chrome w/clear coat) Moe's Driveshaft Loop Sharadon Performance SP-1 Heads (With Cowbell) Moe's SNIPER Cam Phoenix Torque Converter 2600-2800 stall (GREAT MOD) Innovate Technologies wideband Air Fuel gauge p/n 3781 NGK 2314 Plugs Pacesetter Longtube Headers Magnaflow High flow cats Maganflow 2 1/2" Xpipe muffler Flex-A-Lite Electric fan TCM mod Superchips 3715 Weld Velociti 5 wheels Vararam intake (waiting install) Fan Shroud Delete Mod with Alum. Overflow bottle and Washer fluid bottle SRT-10 Hood SRT-10 front bumper Billet door handles Billet seat handles Mag-Hitec diff cover Slammed1 1 1/2" front coil drop Taylor shorty wires(10.4mm black) Hemi Orange valve covers Slammed1 roll pan |
||||
|
 |
thanks that help me out alot I am putting 4.56's in really soon thanks alot great info CTH.
    |
|||
|
|
"Marc" President Eastern Canada Chapter  |
Any pics of the grind area?
       |
|||
|
| Powered by Eve Community | Page 1 2 |
 | Please Wait. Your request is being processed... |
|
Copyright HemiTruckClub.com 2009