Disable the Torque Management on an '03. I can't remember what to do.

This only works on the '03 models...

1)Disconnect battery
2)Remove the TCM connector by loosening the 8mm bolt.
3)Remove the plastic shroud over the connector wire bundle. Has 4 clips holding it on.
4)Locate pin #10 with the yellow wire/ green stripe.
5)Remove the red clip on the TCM side secureing the group of wires having pin #10. Be gentle, I found a small thin knife blade works well. Pry up a little on each corner of the clip at a time.
6)Once the red clip is removed, you will need a straight pin and a flash light. Using the flashlight, look down inside the connector where the red clip was and you will see a small tab holding each wire in place. Use the straight pin to pry the tab away from the wire slightly and at the same time push pin 10 wire into the connector then pull out. The wire should pull out fairly easy doing this step correctly.
7) Once out, replace the red clip, tape the end of pin 10 wire with electrical tape and bundle it on top of the wire bundle going into the connector. Replace the plastic shroud over the wire bundle then replace the connector into the TCM and tighten the 8mm bolt being careful not to over tighten.
8) Reconnect the battery

Awesome! Thanks!